!   $Id: 5545,v 4.1 1994/07/27 19:10:13 pepsa Exp $

coverpage:

  title_1:         GHRS SIDE 2 PULSE HEIGHT ANALYSIS/ION TEST--CYCLE 4
    sci_cat:       CALIBRATION
    proposal_for:  CAL/HRS
    cont_id:       2851
    pi_fname:      JOE
    pi_lname:      SKAPIK
    pi_inst:       STSCI
    pi_country:    USA
    pi_phone:      301-338-4948
    hours_par:     0.67
    hrs:           Y
! end of coverpage

abstract:

    line_1:        This test performs a pulse height analysis to determine individual diode
    line_2:        response as a function of threshold for HRS detector 2. Based on this
    line_3:        evaluation new thresholds may be determined for optimal HRS operation.
    line_4:        Command blocks ZCTFLIT1 and ZCTFLIT2 will be updated accordingly.
    line_6:        This test will run once during the year. Also included is
    line_7:        one ion test which is a PHA of twice normal threshold to look for
    line_8:        ion events (which accelerate back up the 22 kV potential of the
    line_9:        tube, liberate electrons from the phocathode, and produce events
    line_10:       of twice normal energy (this should be a very low, stable rate)).

!
! end of abstract

general_form_proposers:

  lname:           SKAPIK
    fname:         JOE
    inst:          STSCI
    country:       USA

!

  lname:           HULBERT
    fname:         STEVE
    inst:          STSCI
    country:       USA

!

  lname:           SHERBERT
    fname:         LISA
    mi:            E.
    inst:          STSCI
    country:       USA

!
! end of general_form_proposers block

general_form_text:

  question:        2
    section:       1
    line_1:        GHRS Objectives:
    line_2:        1. Verify threshold electronics.
    line_3:        2. Determine the optimal HRS thresholds.
    line_4:        3. Check on ion events.

!

  question:        3
    section:       1
    line_1:        The HRS DEBs are turned on, and the ZCOPHA command block is executed
    line_2:        to generate the required science data. The default thresholds are then
    line_3:        reloaded and verified.  An ion count will be performed
    line_4:        in addition to the PHA. The same command block (ZCOPHA) is used for
    line_5:        both the PHA and the ion count.

!

  question:        5
    section:       1
    line_1:        This test should be run well outside the SAA.
    line_2:        The test is to be done once in Cycle 4.

!

  question:        5
    section:       2
    line_1:        This is an internal test and does not require any special pointing of the
    line_2:        telescope. This test does not require the HRS to be the prime SI.
    line_3:        There is no target list with this proposal.

!

  question:        7
    section:       1
    line_1:        1. The science data will be reduced offline to generate new thresholds.
    line_3:        The load threshold command blocks in project database will be updated with the
    line_4:        new thresholds.

!
!end of general form text

general_form_address:

  lname:           SKAPIK
    fname:         JOE
    category:      PI
    inst:          STSCI
    addr_1:        3700 SAN MARTIN DRIVE
    city:          BALTIMORE
    state:         MD
    zip:           21218
    country:       USA
    phone:         301-338-4948

!
! end of general_form_address records

! No fixed target records found

! No solar system records found

! No generic target records found

exposure_logsheet:

    linenum:       2.000
    targname:      INTFLAT
    config:        HRS
    opmode:        PULSE-HEIGHT
    aperture:      NONE
    sp_element:    SAFE2
    num_exp:       1
    time_per_exp:  600S
    priority:      1
    req_1:         CYCLE 4/2-6;
    comment_1:     GATHER SCIENCE AND ENGINEERING DATA
    comment_2:     FOR ZCOPHA-SIDE 2. ZBEG=30,ZEND=129,
    comment_3:     ZINC=1,ZINTTIME=6.0S

!

    linenum:       4.000
    targname:      ION
    config:        HRS
    opmode:        PULSE-HEIGHT
    aperture:      NONE
    sp_element:    SAFE2
    num_exp:       1
    time_per_exp:  1275S
    priority:      1
    param_1:       BEGIN=57,
    comment_1:     GATHER SCIENCE AND ENGINEERING DATA
    comment_2:     FOR SIDE 2 ION TEST USING ZCOPHA.
    comment_3:     ZBEG=57,ZEND=255,ZINC=2,ZINTTIME=
    comment_4:     12.75S

!

    linenum:       6.000
    targname:      DARK
    config:        HRS
    opmode:        THRESHOLD
    sp_element:    SAFE2
    num_exp:       1
    time_per_exp:  14M
    priority:      1
    param_1:       FUNCTION=BOTH,
    comment_1:     LOAD AND EXECUTE ZMETHRES (LOAD AND
    comment_2:     VERIFY) SIDE 2.

!
! end of exposure logsheet

! No scan data records found